When your garage door malfunctions and you hear strange
noises coming from the opening and closing device, take a few minutes to check
the hardware and ironwork system to identify the cause. Do not wait until your
car is stuck inside before doing this inspection!
Above all, do not tell yourself it's not important because
your electric garage door opener is critical to your garage door! Always
remember that it is this mechanism that makes what you would do by hardly
lifting your garage door. Here are 5 tips that will help you determine what's wrong
with your mechanism.
The bottom of the
door does not close completely on both sides
It may be that one of the hoisting ropes is not properly
adjusted to the drum in which it is wrapped. Or that the screw that fits into
the drum to connect it to the tube is loosened.
Do not try to solve this situation yourself. Contact a
professional garage door repairer. The spring - tube - drum - cable - bottom
hinge system is interrelated and supports a heavy load while being under high
tension.
You Might Be Looking for: Garage Door Safety Tips
You Might Be Looking for: Garage Door Safety Tips
Lift of the
concrete slab
If your garage door leads to a garage located in the
basement of your home, the concrete slab may have been lifted from the ground
filled with water during the thaw. If the drain is defective or blocked, the
floor fills with water and swells. This puts a lot of pressure on the slab,
lifting it up a bit and making the garage door difficult to seal on the
threshold.
Make sure the drain is functional to prevent further lifting
of the floor and concrete slab. Sometimes, pyrite can also cause swelling of
the ground and lifting of the concrete slab.
The wheels are to
be changed
Your garage door may open badly because the casters (located
on either side of the garage door) are in poor shape. If they are too worn,
slide instead of rolling, or they are getting out of the rail, it must be
checked. In addition, the hinges that support them are they properly attached
to the door?
The system rail / wheels / hinge are under high tension.
Contact a garage door repair specialist for a safe inspection and repair.
The rails must not
move
If they are not screwed securely (bolts tight), the rails
could move and prevent the garage door from opening and closing. These are
attached to a triangular metal fastener. Take a ladder or stepladder and
tighten the bolts, making sure the rails are in place (parallel).
The opener does
not ensure that the door closes completely on the threshold
Depending on the type of door opener you have, you will
normally find "up" and "down" arrows on the side of the
motor housing.
Adjust the screw by turning it a quarter of a turn then tries
to open your door by pressing the arrows. Readjust as needed.
Read More: Diy Garage Door Springs
Read More: Diy Garage Door Springs
Maintenance and
verification
In order for the garage door opening and closing mechanism
to be functional for many years, it is important to have a careful
(professional) check done every year. Especially if you use your garage door
every day. If you detect abnormal noises, things that look worn or do
not work properly, contact us right away. We are specialized in garage door
opening / closing mechanism repair. We have the experience and skills to answer
all types of problems related to the proper functioning of your garage door.
Our annual Focus Program will ensure that everything is in order for the winter
season.
No comments:
Post a Comment